The EnConn Power over Ethernet extender (PoE) - eco-power100T/R is a "PoE extender over coax" solution. By using novel RF technology, it can extend the transmission distance of power and 100Mbps Ethernet data over 200~300m (650~980ft) of RG6 video-grade coax cable & 100m UTP in RX side.

EnConn's Power over Ethernet extender, the PoE power and signal from PoE switch or PoE injector are input into eco-power100T and converted into coaxial cable. eco-power100R receives the signal and power from coaxial cable and converts back to PoE interface. This solution allow user to provide 200~300m PoE link by a simple. reliable and cost-effective method.

• Power over Ethernet (PoE)

• PoE extender over coax

• Standard: IEEE 802.3af

• Speed: 10/100 Mbps, full duplexer

• Cable: RG6 video-grade coaxial cable or above

• Transmission distance: 200~300m(650~980ft) coaxial cable + 100m UTP in RX side

• Power Consumption: TX <=1W , RX<=2.5W

• Class 3 powered device available

• Output/Input Interface: BNC connector

• IP Security Surveillance over existing coax cable with powering

• Fast and easy to install

• Scalable

1. 30W PoE injector : PD-7001G 55V, 0.57A

2. 15.4W 802.3af SW:  standard POE Switch, 48V/375mA.

3. Cable DC Resistance = DC Resistance of Cable Inner conductor + DC Resistance of Cable Shield.

4. Typically, regular resistance of  RG 6  is 13 ohm/100m.

5. Typically, regular resistance of  RG 59  is 17 ohm/100m.

6. Typically, regular resistance of  RG11  is 4.9 ohm/100m.

7. Resistance of Low resistance RG6 such as WC5CFB16-200H is 3.7 ohm/100m.

8. Resistance of Low resistance RG11 such as WC7CFB-A is 2.4 ohm/100m.

9.DC Cable Resistance should include Lan UTP Cable, 10ohm/100M (for standard POE interface, cat 5E)